Chat & Social > The Bar - General Chat
Side exit exhaust
Rob110:
This is how not to do it, the previous owner cut a big square hole in the new td5 rear body then covered it over with chequer plate with a hole for the exhaust. the exhaust was a right bodge and it rattled really bad so i have fitted a std one on.
What am i going to do about the big hole??
Guy90:
--- Quote from: "davidlandy" ---I am gonna make my own system - just gonna get some 75mm pipe and chat up Robbie to borrow his pipe bender.
the only issue I have unanswered at the minute is about cutting a nice neat 80mm hole!
--- End quote ---
You know what I'm going to say don't you :twisted: :twisted: :twisted: . Two words. One begins with E and the other with F :lol: :lol: :lol: :lol:
I have the same as Ian but without the trick silencer. My finisher is by Devon 4x4. Pic in my gallery.
bullfrog:
Heres mine. I made it from Y piece back with 2 bombs . I now have a finnisher for the exit.
Cassillis:
Sorry Bullfrog i got it into my head you made/sold them on your website but checking back i see that's not the case :roll: :oops:
Littledan:
--- Quote from: "Davers" ---This is how not to do it, the previous owner cut a big square hole in the new td5 rear body then covered it over with chequer plate with a hole for the exhaust. the exhaust was a right bodge and it rattled really bad so i have fitted a std one on.
What am i going to do about the big hole??
--- End quote ---
carry on with the checker plate mate :D
all the way across the door :D
dan
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version