Chat & Social > The Bar - General Chat
Side exit exhaust
Porny:
--- Quote from: "davidlandy" ---
I shall probaly end up like you say drilling loads of little holes and joining them up but I suspect that it will look crap because of the tatty edge
--- End quote ---
That's easily sorted, I can sell you a nice exhaust finisher for the body work!!
As mentioned my exhaust was made by Chris at www.exactfabrication.co.uk - if you want any pictures give me a shout.
Mine is 2.5" stainless steel tubing - virtually straight through with one small silencer underneath.
--- Quote from: "davidlandy" ---am gonna make my own system - just gonna get some 75mm pipe and chat up Robbie to borrow his pipe bender.
the only issue I have unanswered at the minute is about cutting a nice neat 80mm hole!
--- End quote ---
In all honesty anything bigger than 2.5" isn't really needed.... with 2.5" you will be flowing more than enough exhaust gas.
And hole wise, you need more than 5mm clearance... or else the exhaust will bang like mad!!!
Ian
davidlandy:
Ian
so what bore is that pipe?
like the finisher, where did that come from?
my exhaust is planned to be exiting through the rear quarter lower panel which is chequer plated on mine
Porny:
--- Quote from: "davidlandy" ---Ian
so what bore is that pipe?
like the finisher, where did that come from?
my exhaust is planned to be exiting through the rear quarter lower panel which is chequer plated on mine
--- End quote ---
Pipe is 2.5" OD AFAIK.... never measured it!!... is definetly 2.5 but not sure if that is ID or OD.
Finisher.... I make them :wink: (drop me a pm if you want one)
Ian
davidlandy:
how is the finisher held on?
would need for the lip on the inside to be deep as it would have to go thru the chequer plate as well as the panel.
i will pm you when the deed is done!
Porny:
--- Quote from: "davidlandy" ---how is the finisher held on?
would need for the lip on the inside to be deep as it would have to go thru the chequer plate as well as the panel.
i will pm you when the deed is done!
--- End quote ---
Hidden screws!! - bolts go into the back of the finisher, prefer the fact you can't see the mounting bolts!!
To make the lip deeper isn't a problem.... can make them any size needed.
Ian
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version