Vehicle & Technical > Series Land Rovers

changing series front end to a 90

(1/3) > >>

landroverkeith:
How would i go about changing the front of my series to look like a 90?

about as much as i know is that i would need a slam panel from a 90 lol eint i full of knowledge

Rich_P:
I must ask, why do you want to change the front end?

cherokeegraham:
Don't do it!

Bob Ajob:
Sell it and buy a 90!

I notice you have a 1977 Series IIa with a V8, is it this you're changing the front end on?

By the way, it's a Series III, Series IIa production stopped in 1971 (K). Got a pic of the front end?

Rich_P:
I think this is his V8 Series.  If it is, then that is most certainly a Series 3 front end and Series 3 hinges.  But the bulkhead is a Series 2A bulkhead by going off the widnscreen hinges...  :?

I think I know what it is.  If it is an Ex-MOD vehicle, or a vehicle that was not registered on the roads until '77 then it could very well be a 2A.  I'd say it's a 2A from 68-71 due to the location of the lights in the wings and lack of a vent hole on the passenger wing.  While the grill is a Series 3 grill, a common replacement to "upgrade" the 2A to 3 when the 3 was in production and thus worth more.

Navigation

[0] Message Index

[#] Next page