Vehicle & Technical > Defender

When fitting a 200tdi in a 90

<< < (3/4) > >>

Miniman:
so mike you used a disco pressure plate ?


--- Quote from: "davidlandy" ---we did one the other week and any other questions on the conversion?
--- End quote ---


Well as it happens yes. What did ya do about the oil cooler pipes did ya get em professionaly extended ?

What did ya do about the Power steering hi pressure pipe.

graham2306:

--- Quote from: "Miniman" ---so mike you used a disco pressure plate ?


Well as it happens yes. What did ya do about the oil cooler pipes did ya get em professionaly extended ?

What did ya do about the Power steering hi pressure pipe.
--- End quote ---


When we did mine we used the Disco clutch.  I took the oil cooler pipes and power steering pipes over to Pirtek and they made up new ones.  make sure you measure up well and get the dimensions right as it aint cheeap or easy to change them if you get them wrong.  You may find a local agricultural engineer who can do the job cheaper than Pirtek.

Ja1983:
sounds like i`m not the only one planning a new school diesel lump in the defender!  :lol:

Xtremeteam:

--- Quote from: "graham2306" ---
--- Quote from: "Miniman" ---so mike you used a disco pressure plate ?


Well as it happens yes. What did ya do about the oil cooler pipes did ya get em professionaly extended ?

What did ya do about the Power steering hi pressure pipe.
--- End quote ---


When we did mine we used the Disco clutch.  I took the oil cooler pipes and power steering pipes over to Pirtek and they made up new ones.  make sure you measure up well and get the dimensions right as it aint cheeap or easy to change them if you get them wrong.  You may find a local agricultural engineer who can do the job cheaper than Pirtek.
--- End quote ---

i used defender/TD oil cooler pipes  :wink:

davidlandy:
the oil cooler pipes from the TD fitted - just needed to take the unions from the oil filter housing and rad from the old td engine.

had to extend the PAS pipe by about 6" or so and a local hydraulic firm did that for not many pennies.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version