Vehicle & Technical > Discovery

crank pulley

(1/3) > >>

blade:
after the distruction of my crank damper i fitted anew one put loctite on the bolt tightened it up as tight as i could but yesterday heard a tapping noise stuck my hand up and realised i could move the washer slightlyso tightened it up again.
anyone ideas how to stop this happening again

bobtail4x4:
plastic metal to take the slack up?

johnpirate:
I used sleeve and bush loctite and borrowed a commercial garages torque wrench so I could get it as close to the ridiculasly high setting its never come loose since.

blade:
how did you stop engine turning handbrake and 1st gear dont seem to work

hobbit:

--- Quote from: "blade" ---how did you stop engine turning handbrake and 1st gear dont seem to work
--- End quote ---


1st gear low range + diff lock, and chock all 4 wheels :wink:

Navigation

[0] Message Index

[#] Next page