Vehicle & Technical > Discovery

rear door ladder

(1/3) > >>

tonka toy:
I have just bought a rear ladder for a mk1 disco, it came with a small bar that the so called instructions said should be bolted to the chassis.

Does any body have any ideas where this bar should go or wether to use it at all and just use the four mounts.

Any thoughts.

cheers

 neil

gords:
It sounds to me like the "tool" used to install the captive nuts - what a b****** job that was :roll:

Be very exact with the size of holes you drill and follow the instructions ... and good luck :wink:

tonka toy:
Gords

all the instructions say is to bolt this bar to the chassis,  nothing else.

is it best just to use the four holes on the ladder and forget the bar

neil :?

Damonski:
Is the bar a supporting brace for behind the metalwork which the ladder can bolt through to stop the nuts pulling through the bodywork ?

gords:
With my ladder, I had a bar with one hole it it. It was used to install the captive nuts underneath the number plate and on top of the door.

There was not anything other than the ladder that fixed onto the car. maybe you have a different design of ladder?

Navigation

[0] Message Index

[#] Next page