Vehicle & Technical > Mitsubishi

Modifying Mitsi

<< < (4/4)

Mutz:
And the bumpers Geordie, wouldnt remove steps tho as they are the same height as the components underneath and protect your plastic sills looks higher but you dont actually gain anything.

LandRoger:
Ive removed the plastic sill cover and just fitted some rock sliders made from 65mm roll bar tube slash cut at the ends , looks cool and can jack
up on them too -rock solid,

Super paj boy:
i not sure wot wheels they got on as they came with it on 4 months ago. how easy is it to turn up the torsion bars? Did u get that snokel sorted and have you tryed it out yet? Have you any pics yet of it

LandRoger:
If you go here-www.4x4 wire.com  it has a piece about the torsion bars,
really is quite simple -before you start make sure to measure the distance
from floor to top of wheel arch so that you can then see how much you have raised it,measure after trying out around the block to settle it down,
make sure both sides are even, dont wind them out more than 30mm
or the driveshaft boots will split and you can knack the shafts,
hope this helps,

Navigation

[0] Message Index

[*] Previous page