Chat & Social > The Bar - General Chat

Has anyone one of these

<< < (2/2)

Edge:

--- Quote from: "RedlineMike" ---hehe,i can explain how to make one,


take a bit of exhaust pipe bout 1 1/2 inchs long of a suiatble size that the centre pin will go up inside,weld a large flat washer over one end,take a m8 bolt (13mm head) + run a nut up to the top,screw the pipe over the top of the peg with the nut & bolt sticking out,tighten the bolt up & then unscrew the nut so it then pull s the peg out
--- End quote ---


Nice one Mike :wink:  I'll have to remeber that......as no doubt i'll be needing to use one soon.

Range Rover Blues:
Bit of pipe, washer, nut and bolt.  Use the nut on the bolt to do the pulling rather than the bolt into the spigot.  If it won't budge, blowlamp.

Navigation

[0] Message Index

[*] Previous page