Chat & Social > The Bar - General Chat

Has anyone one of these

(1/2) > >>

Colin 009:
Hi I need to change the seal in my rear diff, has anyone got and could  lend me the puller to take this apart.

PUX:
can u wait till tomoz cus i have made me own i will take a picture

Xtremeteam:
hehe,i can explain how to make one,


take a bit of exhaust pipe bout 1 1/2 inchs long of a suiatble size that the centre pin will go up inside,weld a large flat washer over one end,take a m8 bolt (13mm head) + run a nut up to the top,screw the pipe over the top of the peg with the nut & bolt sticking out,tighten the bolt up & then unscrew the nut so it then pull s the peg out

PUX:
ere all u need is a length of bar the weld a high tensile bolt on the end being the rite thred for the hole than a large weight so its like a slid hammer ere is a pic but i bent the bolt lol and i cant find the weight lol

Colin 009:
Thanks guys,

now can anyone teach me how to weld and lend me a welder :roll:  :wink:

Navigation

[0] Message Index

[#] Next page