AuthorTopic: Wiper Mistary  (Read 1087 times)

0 Members and 1 Guest are viewing this topic.

Offline Big Rich

  • Posts: 799
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Wiper Mistary
« on: May 21, 2006, 15:39:17 »
I have a windscreen wiper mistary :?

The problem...

When you use the wipers they work no problem but sometimes they will wipe all the glass and sometimes they stop before returning to there "parked" position and sometimes don't get to the full wipe possition.

It seemes to make no differance if the screen is wet or dry.

Its anoying when they stop half way up the windscreen.

Anyone know how to sort this out?

Many thanks in advance.

Rich
The difference between men and boys.....
Is the size of their toys.

2003 Discovery 2 "Buck"
1991 Discovery 200Tdi "ROO"   
1986 110 Hardtop "Crash"        
1969 Series 2b Forward Control "Manfred"
1956 Series One "Scrat"
1991 Range Rover 3.9 EFi "Diego"

www.bigrich.org.uk


Clean Green Posse #6<img

Offline danielh89

  • Posts: 174
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Wiper Mistary
« Reply #1 on: May 21, 2006, 16:12:19 »
if when they stop can you then push them down easly by hand? if so the gearbox's are probly worn.

if they dont go down by hand the park switch might have corroded up.

Dan

Offline Skywalker

  • Posts: 357
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Wiper Mistary
« Reply #2 on: May 21, 2006, 16:40:46 »
Don't now what causes it but mine does it as well, usually sorts itself out after ignition has been turned off for a while so I suspect it's something in the electronics.

Dave
WIP ........ just Keeps Changing .......

SW

Edge

  • Guest
Wiper Mistary
« Reply #3 on: May 21, 2006, 17:07:13 »
:lol:  :lol:  :lol: Mine go off the windscreen both ways (up/down), then work normally then go off screen again......quite annoying really but they work and it doesnt seem to be ruining the wiper rubber.

Offline hobbit

  • Posts: 4750
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Wiper Mistary
« Reply #4 on: May 21, 2006, 19:15:02 »
Sounds like the park mechanism in the wiper unit, its usually a contact setup (or used to be when I last stripped one).

They keep the motor turning to a set point on a crank in the case, and then it cuts off the power and it stops

If you can get then unit out, its possible that the contacts could be fouled up, but more than likely they will be shot. It will work ok, you just have to park them on the stalk. Unless you replace the unit
Kev

'91 stretch Discovery 200 Tdi
Hybrid for running round (got to go now)
Srs 3 Lightweight petrol (got to go)
Srs 3 Lightweight petrol, runabout

Not every problem can be solved with duct tape, and it's exactly for those situations we have WD 40

Offline Big Rich

  • Posts: 799
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Wiper Mistary
« Reply #5 on: May 21, 2006, 20:20:17 »
Quote from: "danielh89"
if when they stop can you then push them down easly by hand?


Yes you can push them down easly.

Rich
The difference between men and boys.....
Is the size of their toys.

2003 Discovery 2 "Buck"
1991 Discovery 200Tdi "ROO"   
1986 110 Hardtop "Crash"        
1969 Series 2b Forward Control "Manfred"
1956 Series One "Scrat"
1991 Range Rover 3.9 EFi "Diego"

www.bigrich.org.uk


Clean Green Posse #6<img

Offline unknownmanxman

  • Regional Rep
  • *
  • Posts: 297
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Wiper Mistary
« Reply #6 on: May 21, 2006, 22:00:19 »
This happened to mine and the wiper motor was on its way out...
Jon - The Unknownmanxman

I have taken a vow of poverty - to annoy me, send money

2005 - Defender 90 TD5
1991 - Defender 90 200Tdi - See the spec http://www.j33p.org/_club/rides_view.cfm?ride_id=36
PTO H14W SE - one of a kind im told
2 Door, 90" RR - 43% Magic

Series 1 V8 trialler

Isle of Man GLASS Area Rep


Offline danielh89

  • Posts: 174
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Wiper Mistary
« Reply #7 on: May 21, 2006, 22:27:57 »
id say its the gear box's but check other stuff first because they are a pig to get at :(  

Dan

Offline jimthelandyman

  • Posts: 447
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Wiper Mistary
« Reply #8 on: May 23, 2006, 09:34:21 »
Mine has the same bloomin problem even after a recent change of wheelboxes, i was wondering whether the motor is on its way out.

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal