Vehicle & Technical > Series Land Rovers

Braking News

(1/2) > >>

rustprooflandyracer:
Reports just in that I will be changing a wheel cylinder tomorrow, recent evidence seems to suggest un even braking, with a definate pull to the right and leaking oil from the bottom of the drum. Many individuals say this task is riddled with trickyness with the added factor of bleeding the brakes prooving hard. If you wish to provide any information on this topic please leave a message below. Your time is appreciated.

If you didn't understand that  :? is there any tips etc to changing a wheel cylinder.

Cheers Matt

muddy_90:
they only problem i had chaging mine was the nuts wouldnt come undone so i broke the nut in half using a hammer and chisle


Matt

hobbit:
As said the main problem is the pipe to the cylinder, the rest is pretty straight forward, usually I get shoes and an adjuster kit, just in case the one on the thing is had it too. Also have a look at the drum, for wear

They bleed up fairly good, if you have an ezi bleed kit makes it easier but on a series normally no probs

mark.yellow.series.3:
i have found those pressure brake bleeding kits very useful for 'the antichrist'

Litch:
I never had a problem bleeding Series brakes apart from once I had a brand-new master cylinder which turned out to be faulty, the supplier replaced it and everything was ok. Having said that, I may have just been lucky (I hesitate to say it was just pure skill!) but cannot recomend the Ezibleed highly enough. I bought one a few years ago (after my Series ownership had ended) and it makes a 2-person job a very quick 1-person job (can bleed my 90 in 10-minutes).

Navigation

[0] Message Index

[#] Next page