Chat & Social > The Bar - General Chat
QT radius arms ....
mark.yellow.series.3:
i just put things on in a hurry (because iam impatiant)
then discover ive done it wrong, swear alot, and then do the job properly.
my advise to anyone is, even if its an arse to rectify, do the job properly and then you can sleep better at night.
Bob696:
They fit so cant be arsed to swop em over just so the writing isnt back to front. Wont see it when they are covered in waxoyl and mud :P
I put a set of deflex bushes on the radius arms as they went in (and brand new bolts etc). Thats the shocks and radius arms with new bushes. Will take it out for a spin in a bit (probably to the chippy).
paul_humphreys:
--- Quote from: "defenderdan" ---Paul, i have QT 3 degree arms on my motor with a 2" lift and i honestly can't tell the differance in handling from standard arms. I only use them because they are cranked, which helps the bushes. My advise would be to run your motor for a while when you have lifted it and see how it feels.
--- End quote ---
I had a +2 inch lift on my RRC, without them. So I will try.
Paul
chuggaman:
--- Quote from: "Bob696" ---They fit so cant be arsed to swop em over just so the writing isnt back to front. Wont see it when they are covered in waxoyl and mud :P
I put a set of deflex bushes on the radius arms as they went in (and brand new bolts etc). Thats the shocks and radius arms with new bushes. Will take it out for a spin in a bit (probably to the chippy).
--- End quote ---
you just know its going to bug you....................
mike
Bob696:
--- Quote ---you just know its going to bug you....................
--- End quote ---
What will ???? :P
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version