Chat & Social > The Bar - General Chat
QT radius arms ....
Bob696:
are the 'handed' as in is there a left and a right one?????
I have just fitted mine with just one bolt to go and I noticed that the "QT 3" cut into both reads inside out on both unless you look from underneath when they read correct. This means I have put them on the wrong side (hope all this makes sense).
Question is ...... Is this just cosmetic or have I screwed up????? :oops:
BTW they are the castor corrected radius arms
Rangie3.0LtrDan:
from the articly in LRM from last month or this month its just cosmetic, but he turned them round as a mark of respect to the fella at QT.
Bob696:
--- Quote from: "Disco200TDiDan" ---from the articly in LRM from last month or this month its just cosmetic, but he turned them round as a mark of respect to the fella at QT.
--- End quote ---
Thank god for that :shock: :lol:
I like the guys from QT but not enough to spend the time swopping them over again :twisted: :P
paul_humphreys:
Bob, Let me know how it drives after you have finished. I am thinking about some for my 110 when I do the lift.
Paul
defenderdan:
Paul, i have QT 3 degree arms on my motor with a 2" lift and i honestly can't tell the differance in handling from standard arms. I only use them because they are cranked, which helps the bushes. My advise would be to run your motor for a while when you have lifted it and see how it feels.
Navigation
[0] Message Index
[#] Next page
Go to full version