Pages: [1]   Go Down

AuthorTopic: Where would I get good wheel spacers  (Read 668 times)

0 Members and 1 Guest are viewing this topic.

Offline tim-green

  • Posts: 36
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Where would I get good wheel spacers
« on: April 01, 2006, 20:51:55 »
Just bought some alloys for my defender, however it has the older axles, so will need spacers to put the center caps on, however I have been told that there are some good one's but also some dangerous one's, :shock: has anyone got any experance of these and could anyone recommend were to get a good set :?:
Logged

Offline Budgie

  • Regional Rep
  • *
  • Posts: 2217
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • This post is best viewed on a computer.
    • Lochaber
  • Referrals: 0
Where would I get good wheel spacers
« Reply #1 on: April 02, 2006, 00:29:36 »
Make sure they are TUV tested and approved and that they have centering lugs to locate the wheel and are not flat.

Devon 4x4 do them and they may do different thinknesses.  :wink:

Photo below is from Scorpion's site and shows the lugs, their's are also TUV tested.
Logged

Offline Richie_EB4

  • Posts: 520
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Where would I get good wheel spacers
« Reply #2 on: April 02, 2006, 15:58:43 »
Also looking for a set but what is TUV tested ??

Cheers
Logged
Where there is mud there will be someone stuck.........then the fun begins

Owner www.4x4lrs.com

Administrator  www.4x4uk.org

4x4RNE Commitee member www.4x4RNE.co.uk

Defender TD5...K88 MUD
2" lift
Mach 5 rims with 33/12.5/16's
Mile marker H12 with 9.5mm Plasma rope
Steering Guard and front and rear diff guards
Safari Snorkel and roof light bar.

Offline Budgie

  • Regional Rep
  • *
  • Posts: 2217
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • This post is best viewed on a computer.
    • Lochaber
  • Referrals: 0
Where would I get good wheel spacers
« Reply #3 on: April 02, 2006, 21:05:51 »
It is a safety & type approval. Have a look HERE for more info.  :wink:

I think Tim can tell you more about it that I can.
I wanted a set of spacers that had been tested, not something done in someone's garden shed on a wee lathe that could fail on me!!  :wink:
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal