Vehicle & Technical > Series Land Rovers

Rock Slider mounts.

(1/2) > >>

Devon-Rover:
Hi on my IIa i have a lovely set of DIY box section sliders to go on but i have a question!?

Is there any ideas and advice on how i can mount them on the back. So the fuel tank outrigger and the outrigger on the other side too. Is there any pictures i could see so i can figure out how i can work out my mounts.

Will i have to 'beef' up my outriggers to take the strain imposed when i use them?

All thoughts veiws and advice welcome.


Cheers

Sharpshooter:
That is where they mount on the 90, and on my 110 Commercial. I think they should be ok. Someone with a series has probably got them, and will know for sure. :)

fire boy si:
hi

ive got them fitted to my 72' swb series 3 mine were made by mill services and bolt on to the front out rigger and the tank out riggers on my truck speak to the guys there they may even be able to send you a copy of there instructions to help you out

laters si :D

Devon-Rover:
talking to  the chap at mill servics a year or so ago he was very resiliant in to talking to non customers due to the fact they would use his idea's for mounting and the design for the rock sliders, and so not make any sense for him to make his for what litttle financai gain he has on hs products.

fire boy si:
did you get your sliders sorted i will have a look for my copy of the instructions and scan them and i can email them to you if that would help  :)  :D
later si

Navigation

[0] Message Index

[#] Next page