Vehicle & Technical > Series Land Rovers

Rock Slider mounts.

<< < (2/2)

Devon-Rover:
No i haven't yet.

I have some ideas but a copy of your book would help a lot as it'll let me know that what i will have doen is ok. And if it isn't i will do what the instructions say.

A few pictures would help, if you could PLZ?

Devon-Rover:
Stil very stuck for idea's and it is getting desperate as they were very much needed after almost sliding into a tree a few days ago.  :shock:

I have found this site

http://www.negativearth.com/New_Folder/Jackablesillsy.html

So might be a bit of help to anyone else who is thinking about doing the same.

rustprooflandyracer:
Hey got them fitted to mine, basically the front section should be a hole which the chassis bolt goes through, connecting them at the front... Then for the rear I made some angle brackets, at 90 degrees to each other, this allows them to be bolted to the back of the outriggers. I would take a pictue but my digital camera is truly terrible and it isn't bright enough to get a good pic. I decided to use my own fitting system at the rear....

Cheers Matt... There are some pictures in my photo gallary.

fire boy si:
did you get the pictures rowan sorry i had to do them with the camera if you want i'll send them in the post to you

fire boy si

Devon-Rover:
No worries i did reply. It must have got lost somewhere in the WWW.
Thanx for the instructions i now have a chap who can do my welding for me.

Navigation

[0] Message Index

[*] Previous page