Pages: [1]   Go Down

AuthorTopic: Towing  (Read 349 times)

0 Members and 1 Guest are viewing this topic.

Offline rustprooflandyracer

  • Posts: 143
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Towing
« on: October 26, 2005, 22:14:55 »
How would I go about fitting heavy duty springs to the rear, is it a case of jacking it up slipping out the old ones. jobs a good'n?
Logged
Matt

Land Rover 1983 88'' CSW, CP Parabolics (3 leaf rears), Recon Turner 2 1/4 diesel, BFG Mud terrains on silver mods (235/85/r16), Galvanised chassis, Midland CB fitted, Rock Sliders, Snorkel, Light Bar. Full NAS Lights, Powerflow Exhaust, Twin Hiclones... and some!

Disco 300TDI - BFG AT's, Light Bar... Work in progress!

Offline Jake

  • Regional Rep
  • *
  • Posts: 5474
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • <insert witty comment here>
    • South Molton, Devon. UK
  • Referrals: 0
Towing
« Reply #1 on: October 26, 2005, 22:29:46 »
From what i saw 2 days ago you jack up the chassis and stick it on an axle stand.
jack up the axle and remove the wheel.
loosen the top shock bolt. undo the bottom of the shock and remove the lower part from its seat.
undo the 2 retaining plate nuts inside the botom of the spring.then lower the axle, slowley until it pops out.
You may need spring clamps for this.
Refit is the reverse.
 :D
Logged
Jake

Owner - Land Rover Discovery 2
Driver - Land Rover Defender 100" Trayback

sparkes

  • Guest
Towing
« Reply #2 on: October 26, 2005, 22:54:50 »
If its for the disco then its easy.

I just fitted airbags in mine and all I did was take the wheel off, undo the bottom of the shock and jack up the chassie.  the spring will come out just before the brake line starts to stretch

Steve
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal