Chat & Social > The Bar - General Chat

wheel's :- inside out

<< < (2/2)

beast5680:
i seem to recall 500bhp posted about turning his wheels around if you do a search :wink:

barmiebrumie:
Hi, have done a search but there is no final yes or no, the welding side of it is not a problem as i am BOC certificated,  might just swap them round when i get  chance just to see what they look like,



John.

Bush Tucker Man:
Can't remember where I've seen it, but there's pictures somewhere on-line of a 10" wide(?)rim with a Range Rover (Rostyle) centre.

Years ago (some point in very early 90's?) in 'Off Road & Four Wheel Drive' magazine, Tony Parrott did the same with one of his 'No Problem' trialers, as supported by the magazine at the time.

TUFFTEE:
Seem's to me that it would put one Hell of a  load on the bearings though? :shock:

Cherry Bomb:
Used to do that on VW based buggies and stuff in the 80's.  Seem to remember that they weren't road legal.  The law was changed as I remember, meant that you could use wheels that had been altered before the regulations changed, but any made after had to be for off road only. (Dunno how you'd be able to tell??)

May have changed again since though....... :?

Navigation

[0] Message Index

[*] Previous page