Chat & Social > The Bar - General Chat

wheel's :- inside out

(1/2) > >>

barmiebrumie:
I know most of you are going to say ''are you mad'', but was speaking to a chap from another forum & he said he had seen a disco owner that had turned his wheel's round (as in revesed them!!!), appantley he had welded up the counter sinking on the outside & contersunk the inside :? ,

anyone eslse heard of this being done :?:  & if so would it be like fitting off set rims or just plain stupid & dangerous :?:


John.

beast5680:
theres someone on here done with their disco in spain is MC member 500bhp? here,s a pic of his disco

dave_2A_2.25Turbo:
Like most things of this type - it's fine if it's been done properly

barmiebrumie:
Hmm, modulers turned outside in that would save a few quid :wink: , might have to order a new dome cutter,



John.

Xtremeteam:
a couple of guys in my club have reversed disco wheels & wht they had done was the centres cut out fliped over & welded back in,also got to move the valve hole aswell,


IMHO DONT do it yourself unless you are a highly competent welder etc,personally if i was doing that they wouldnt get used on the road,

Navigation

[0] Message Index

[#] Next page