Chat & Social > The Bar - General Chat

Ball Joint Seperator

<< < (2/2)

hobbit:
Usually finish up leaning on the joint with a bar, after slacking the nut off, but not removing it, and soaking it in penetrant first.

Then whacking it with a hammer on the side of the joint, not always successful, but nine times out of ten, success :wink:

Henry Webster:
I've never used a ball joit splitter (on a Land Rover) - usually just crack them off with a couple of sharp blows with a hammer on the housing that you want the TRE to be relased from.

Regards

H

Navigation

[0] Message Index

[*] Previous page