Chat & Social > The Bar - General Chat

Ball Joint Seperator

(1/2) > >>

turtle:
Slowly stripping a series 2a just a few more bits to get off like the steering arms  :? I haven't got a ball joint seperator, any ideas what I could use instead?

Or should I go out and buy the proper tool?

Budgie:
Proper tool would be good.
I also find a pri-bar pulling the track rod the way you want it to got and a good thump or two from a lump hammer the side of where the balljoint goes onto works well, saves damaging the seal on the balljoint if you're using it again!!   :wink:

TUFFTEE:
check ebay! Phil! I just bought one! £6.50 inc delivery! Still waiting mind.

turtle:
Cheers guys :D

Might venture down to my local tools shop and see what they cost, as its raining I wont be doing any work on the motor until it stops.

Thanks again

turtle:
Got one :D

Had a trundle around the shops, and got one at my Local TMC a Draper Ball Joint Remover for £6.

Can get the job finished now I hope, just need the weather to chear up a bit.

Navigation

[0] Message Index

[#] Next page