Vehicle & Technical > Discovery

Next step?

<< < (2/3) > >>

davidlandy:
i have got the Twisted performance uprated intercooler and with the fuel pump tweak it goes a lot better.  Can easily keep up with my v8 buddies until I run out of gears at about 85mph!

The next step I was looking at was the exhaust - I currently have the standard step up with a cat and am looking to change this it has a few pinholes appearing in it which I weld up and it provides a good excuse for buying one!

how much was it ?

colintandy:
the whole kit fitted was 1000
the exhaust i belive is about 450-475 ex vat but can check on site


dont touque about it twist it

Budgie:

--- Quote from: "colintandy" ---hi budgie just seen your smart disco like the wheel arch flares where can i get a set from or did you fabricate yourself looks very neat and tidy regards colin
--- End quote ---


Colin,

They are from Devon 4x4, fibreglass arches made by Rangie Spares in Oz but as I said, they ain't cheap!!
The 5 door version is worse to fit than the 3 door cos you have to cut into the inner door frame.
It takes about a day to fit all four and I had it down to 45 minutes by the last one.  :D
They are supplied in black gel-coat and you prime & spray them in the colour you want.

chuggaman:

--- Quote from: "GaryPatt" ---Hi everyone, recently joined and not yet been anywher or mewt anyone fro mclub but need some advise please.
Just bought (2weeks ago) my first land rover after 5 yrs with Jeep i have a 96 Discovery TDI. (not sure of model?)
Just picked it up from my new Chappie who has fitted (at great expense..and they say Jeeps are expensive!)
2" Suspension lift/
Procomp gas shocks/
 Front & rear Diff guards/
Snorkel/
Deep wading kit/
Rock sliders/
Steering guard/
 Now want to increase tyre size and look at next mod, so advice please waht  size tyres can i  go to and what else is advisable at this stage?

Gary
--- End quote ---




youll be surprised what you can fit in that arch

but you will need to cut your wings to put the devon arches on

Budgie:

--- Quote from: "chuggaman" --- youll be surprised what you can fit in that arch

but you will need to cut your wings to put the devon arches on
--- End quote ---


Will you ever, it requires about 3" taken out all round each arch and the removal of the plastic inner arches on the front.
Sorry forgot to put that bit in!!  :wink:

Navigation

[0] Message Index

[#] Next page

[*] Previous page