Pages: [1]   Go Down

AuthorTopic: Is the spare wheel holder held with captive nuts?  (Read 439 times)

0 Members and 1 Guest are viewing this topic.

Offline auf_wiedersehen_pet

  • Posts: 1179
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Is the spare wheel holder held with captive nuts?
« on: September 10, 2007, 22:11:49 »
Or do I have to take the rear door panel off??
Logged
Rob Steele

1995 Land Rover Discovery 300 TDi - Everyday Car (Ex Jap)
2007 Toyota Avensis 2.2 T-180 - Sensible Car (Ex TSB Bank)

Offline Blakey

  • Posts: 51
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Is the spare wheel holder held with captive nuts?
« Reply #1 on: September 10, 2007, 22:18:53 »
Yep the rear door panel has 2 come off and the 6 nuts will be smack in the middle.
Logged

Offline blacknight

  • Posts: 124
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Is the spare wheel holder held with captive nuts?
« Reply #2 on: September 10, 2007, 22:27:03 »
Held on with 6 nuts and bolts, so unfortunately the inner card has to be removed to gain access to the nuts.

Had to remove the spare wheel carrier bracket on mine last week due to it being badly corroded.
Logged
1996 Discovery 300 Tdi Auto, 3 Door.
1992 Range Rover 3.9 V8 Auto - LPG & 3" Lift. *Now been sold*

Formally known as pj2629 but had to change Username due to Club Reps memory problem!!!

Offline auf_wiedersehen_pet

  • Posts: 1179
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Is the spare wheel holder held with captive nuts?
« Reply #3 on: September 10, 2007, 22:40:25 »
Many thanks guys. It was not the answer I wanted but at least I know where to start.
Logged
Rob Steele

1995 Land Rover Discovery 300 TDi - Everyday Car (Ex Jap)
2007 Toyota Avensis 2.2 T-180 - Sensible Car (Ex TSB Bank)

Offline Lyndsey731

  • Posts: 191
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Is the spare wheel holder held with captive nuts?
« Reply #4 on: September 11, 2007, 08:40:53 »
A pig of a job on your own if you have short arms like me :cry:

good luck

Gav
Logged

Offline auf_wiedersehen_pet

  • Posts: 1179
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Is the spare wheel holder held with captive nuts?
« Reply #5 on: September 11, 2007, 19:07:42 »
At 6'5" I have long arms BUT the rear door panel is pop riveted chequer plate so this job has gone right to the bottom of the list!!

Thanks all.
Logged
Rob Steele

1995 Land Rover Discovery 300 TDi - Everyday Car (Ex Jap)
2007 Toyota Avensis 2.2 T-180 - Sensible Car (Ex TSB Bank)
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal