Mud-club
Vehicle & Technical => Range Rover => Topic started by: jasonforsythe on June 01, 2010, 13:13:45
-
after getting my replacement box i found the tourqe convertor hanging on the shaft in transit now i think its ok but just a bit nervous after losing one box so the zf hp4-22 box is there ment to be a little play on the centre shaft as it goes into the box shaft and is there any way of testing the pump before i sling it back on
thanks jason
-
i always keep spinning and pushing untill it is sitting deep into the bell housing, if the torque convertor has moved i would replace the input seal as it could leak