Mud-club

Vehicle & Technical => Range Rover => Topic started by: JimP on May 22, 2009, 21:49:06

Title: what diff is in my RRC??
Post by: JimP on May 22, 2009, 21:49:06
What diff is going to be in my 1985 RRC?? a 10spline??

It appears my rear diff is knackered so I need a new one, will one off a Tdi Disco fit??

Cheers

Jim
Title: Re: what diff is in my RRC??
Post by: doda456 on May 22, 2009, 22:15:53
Yes and yes, If unsure about splines just take off a halfshaft and count the splines on the end,

Also it doesnt matter if its front or rear from the donor vehicle. They are completly interchangeable
Title: Re: what diff is in my RRC??
Post by: tack43 on May 23, 2009, 12:20:52
Yours is likely to be a 10 spline. If the donor vehicle is a 24 spline use those shafts and upgrade!  :D

Rich
Title: Re: what diff is in my RRC??
Post by: Range Rover Blues on May 24, 2009, 14:22:13
Yours is likely to be a 10 spline. If the donor vehicle is a 24 spline use those shafts and upgrade!  :D

Rich

In which case get the stub axles too, they have an oil seal inside them that runs on the halfshaft, better than what you have now.
Title: Re: what diff is in my RRC??
Post by: dod51e on May 27, 2009, 09:36:52
Yours is likely to be a 10 spline. If the donor vehicle is a 24 spline use those shafts and upgrade!  :D

Rich

In which case get the stub axles too, they have an oil seal inside them that runs on the halfshaft, better than what you have now.
Do the stub axles have the same number of splines as the shafts?
Title: Re: what diff is in my RRC??
Post by: J.D. on May 27, 2009, 19:08:02
Yours is likely to be a 10 spline. If the donor vehicle is a 24 spline use those shafts and upgrade!  :D

Rich

In which case get the stub axles too, they have an oil seal inside them that runs on the halfshaft, better than what you have now.
Do the stub axles have the same number of splines as the shafts?

Stub axles don't have any splines on them, just a thread on the end for a hub nut.
Title: Re: what diff is in my RRC??
Post by: Range Rover Blues on May 28, 2009, 15:15:53
Yours is likely to be a 10 spline. If the donor vehicle is a 24 spline use those shafts and upgrade!  :D

Rich

In which case get the stub axles too, they have an oil seal inside them that runs on the halfshaft, better than what you have now.
Do the stub axles have the same number of splines as the shafts?

Stub axles don't have any splines on them, just a thread on the end for a hub nut.

YES BUT, the half shaft that come in the 24 spline axles have a journal for an oil seal inside the stub axle.  This arrangement work better than the original design but you need to swap the stub axles as well.
SimplePortal 2.3.5 © 2008-2012, SimplePortal