Mud-club

Vehicle & Technical => Defender => Topic started by: 90Mike on April 14, 2009, 17:22:22

Title: MOD roll bar
Post by: 90Mike on April 14, 2009, 17:22:22

Hi guys got myself a MOD roll bar to fit when i change my roof over but had a quick look today where it sits but the holes in the tub are to small for it to go through they only look big enough for the sticks not a roll bar  :? am i doing something wrong or do the holes have to be enlarged to take the bar it's a c reg county if that make any diffrence  8-[ any help or photo's of the area would be great 

Title: Re: MOD roll bar
Post by: paulnb57 on April 14, 2009, 20:38:55

You need to enlarge the holes...............do you have the brackets that go under the holes and fit into the corner of the tub?
Paul

Title: Re: MOD roll bar
Post by: Mark Y on April 14, 2009, 22:04:27

Need to open up the holes and have corner bits to hold it in place or make your own, give me a shout when you are going to do it I'm sure I have all the instructions in with my kit, then again it's been sitting there for 3 yrs and I still haven't looked inside the box !, this year I think, cheers

Title: Re: MOD roll bar
Post by: 90Mike on April 14, 2009, 23:47:56

Thats cool then at least i am not going mad  :twisted: got the corner sections so bring on the power tools  8-[

Title: Re: MOD roll bar
Post by: floyd fan on April 15, 2009, 17:37:27

Quote from: 90Mike on April 14, 2009, 23:47:56

... got the corner sections ...

I was right then you did need them.