Mud-club
Vehicle & Technical => Range Rover => Topic started by: yellow series 2a on December 09, 2007, 16:27:56
-
Please help.
My 1988 rangie 3.5 V8 will not start i have fuel flow but no spark out of the coil. So i replaced the coil with a new one and still no spark i have power going to the coil but no HT out. Any thought??
Many thanks
-
mite be the crank sensor in the dizzy gone . replacement dizzy is the only answer. maybe
-
Thanks thats what i am thinking is gone
-
Ignition amplifier?
From memory it should either be on the wing next to the coil or on the side of the dizzy with either two or three wires going to it -much much much cheaper than a new dizzy.
Check the reluctor clearance inside the dizzy as well.....
Plus ALL wires -these can get easily broken just through wear and tear...
HTH,
Bowie.
-
I had the same problem with mine changed the coil, dizzy, rotor arm, and put on brand new leads on her, turned out to be sum little ecu white box under the drivers seat, gave it a waggle and it started first fick of the key :roll: so i changed that and shes bein fine since! Give that a try, you never know!!
-
the sure way to find out is with autologic check local mate does it for 30 quid.
-
I'm thinking ignition ampliefier too, but make sure the battery is topped right up, mine won't start either if the battery is a bit too flat.
-
Thanks very much for your hep am going to change the ignition ampliefier hope this shoulg fix it
Many thanks