Mud-club

Vehicle & Technical => Discovery => Topic started by: JPJ on September 21, 2006, 20:33:15

Title: Selecting 4th Gear
Post by: JPJ on September 21, 2006, 20:33:15
For a while selecting 4th from 5th has been a bit crunchy but now I cannot select 4th at all whilst on the move, either going up or going down both high and low box. I can select 4th when its stationary and move off without it jumping out. All other gears are fine.
I remember reading somewhere that a bent linkage could cause this problem.
Any ideas anyone?
Title: Selecting 4th Gear
Post by: driftwood on September 21, 2006, 22:18:53
normally its either worn or damaged gear linkages or the synchroniser units that worn. i think from memory if its a selecter fork it jumps out of the gear but its sound like linkages/sync
Title: Selecting 4th Gear
Post by: hobbit on September 22, 2006, 17:24:08
When was the last time you changed the gearbox oil?

That can sometimes ease these problems
Title: Thanks
Post by: JPJ on September 23, 2006, 22:09:30
Thanks for the advice guys.
It looks like its 4th gear synchro according to various websites that I have been tracking down.
There's only one cure for this - and you guessed it - its expensive!  :(  or I just manage without 4th!
SimplePortal 2.3.5 © 2008-2012, SimplePortal