Mud-club
Vehicle & Technical => Defender => Topic started by: davidlandy on September 06, 2004, 22:20:34
-
Does anybody know what (internal) diameter the correct pipe is?
I want to do the job of extending the breathers properly this time!
-
Fairly sure it's 4mm Dave. Seem to think it's 6mm outside 4mm inside but it could well be imperial ie 1/4" outside, the two are close enough to not matter a jot tho'.
-
Whilst on the topic does any particular type/quality of pipe have to be used ? Will fish tank air pump tube be OK ?
Damian
-
i used windscreen washer hose
the prob seems to be that it kinks to easily and I believe can implode to restrict breathing IMO. so I am going for the proper stiff walled stuff.
I leaking diff pinion seal on the back has prompted this.
Dave
-
I got some pneumatics hose (from RS I think) and used that. Nice and rigid walls but flexible enough for easy routing.
I needed to stick the end in boiling water to soften it enough to fit to the banjo, but once on.. no problems at all.
-
Got mine from local (to work) pneumatics supplier... not that cheap, but very good stuff. In a nice shade of blue too!!!
Think I paid about £15 ish for quite a few metres (just over 10.5m).... more than enough (I think) to do my Landy. Though I still haven't got round to fitting it!!
You can have a look when you come round if you want, might even be tempted to sell the pipe - taking my 90" off the road to rebuild soon, so won't be needing the pipe for quite a while.
Ian
-
just got some - pneumatic hose £9 for 30m!!!
bargain eh?!
choice of colours so i went for green! me likes green u see.
:wink:
-
Where did you get that from ?
Mail Order ?
Damian
-
Corby hydraulic hoses
i shall try and find their website