Mud-club

Vehicle & Technical => Defender => Topic started by: zacjake on August 15, 2006, 18:44:01

Title: Procomp shocks
Post by: zacjake on August 15, 2006, 18:44:01

With my new shocks I only received 2 dished washers.Is it OK to use the internal washers from my old standard shocks?
Thanks :?:

Title: Procomp shocks
Post by: Xtremeteam on August 15, 2006, 19:34:41

you should have got 2 dished washers per shock for the bottom,

Title: Procomp shocks
Post by: adafish on August 15, 2006, 21:41:45

SAME HERE....SO USE THE ONES OF THE OLD ONES..

Title: Procomp shocks
Post by: Xtremeteam on August 15, 2006, 21:47:34

noooo


just twigged



you use one washe ron the top & 1 washer on the bottom with the rubber clamped to the axle no washers in between,

Title: Procomp shocks
Post by: paul_humphreys on August 15, 2006, 21:53:34

You should have 2 for each shock for the rear is its the standard pin to ring. 4 for each front shock pin to pin.

Title: Procomp shocks
Post by: Budgie on August 16, 2006, 00:02:40

What Mikee & Paul said.  :wink:

If you look at the bushes on the bottom of the rear shocks then you should see that one side has a raised section that sits in the hole in the axle, the other end on the bush will be flat (washer side).  :)

Title: Procomp shocks
Post by: zacjake on August 16, 2006, 06:23:12

Sorry forgot to mention they are front shocks

Title: Procomp shocks
Post by: Xtremeteam on August 16, 2006, 07:43:48

yup still the same,rubber eitherside of the chassis & washers on the outside

Title: Procomp shocks
Post by: zacjake on August 16, 2006, 08:03:10

Thanks all.