Mud-club

Vehicle & Technical => Range Rover => Topic started by: Bluebottle on June 10, 2006, 22:43:51

Title: Suspension
Post by: Bluebottle on June 10, 2006, 22:43:51

So, how easy is it to change the springs and shocks on a Rangie?

Title: Suspension
Post by: Xtremeteam on June 10, 2006, 23:42:28

dead easy,can do the whole lot in a couple of hours

Title: Suspension
Post by: p4203 on June 11, 2006, 11:08:24

did mine in two hours the other night but lucky enough had swapped it all a couple of months ago and that took me 5 hours due to a few rusty bits and pieces :oops:

Title: Suspension
Post by: bobtail4x4 on June 11, 2006, 20:59:21

I have been 3 hours doing the rear springs and shocks on my disco today. may have been the heat, but had to grind the shock nuts off.

Title: Suspension
Post by: clbarclay on June 12, 2006, 20:09:53

The real time consumer is if any of the suspension brakets are rusted to bits, which would probably need a fabrication repair job (been there, done that, put weld splatter through the tee shirt).