Mud-club
Vehicle & Technical => Discovery => Topic started by: puddled on January 26, 2006, 21:39:48
-
Hi, does anyone know if the 300tdi dashboard will go in a 200tdi, mines looking a little past its best.
-
You'll have a lot of rewiring for switches, columns, relays, heater controls etc to do as a behind the scenes sort of reminder ;)
No idea if it will fit, I know the two are that different :)
-
I have that to do anyway, the last owner has made a right hash of it, wires hanging here there and every where, most joints made with duck tape
-
It will fit in the gap.
The measure ments between the 2 models are identical.
But, You'd need to change every thing behind the dash.
I believe you'd have to change the dash loom too(?).
Its quite a big job. But its do-able.
-
I think there'd be an issue with the speedo also. Pre 94, the speedo was mechanically driven, post 94 it's electronic. I don't know how easy it's going to be to modify an early vehicle to drive an electronic speedo.
-
where i used to work a guy in the next door unit had a 200tdi with a 300 interior, i was not into landys then and only knew cos he showed me one day when i took an interest in it, he had changed the dash ,seats and the doors i believe
-
I think you will also have to change the heater and all the ducts as well as the centre console.
I would think its a pretty major job and although they may look nicer I doubt you would gain enough the warrant the amount of work.
-
I think Matt_h has a 200tdi dash board for sale if that makes life easier?
-
Turtle has one too look here or in the for sale section
http://cgi.ebay.co.uk/Land-Rover-Discovery-200tdi-Dash_W0QQitemZ4607418423QQcategoryZ31348QQrdZ1QQcmdZViewItem
-
I think there'd be an issue with the speedo also. Pre 94, the speedo was mechanically driven, post 94 it's electronic. I don't know how easy it's going to be to modify an early vehicle to drive an electronic speedo.
all you would have to do is swap the drive in the Tbox for the correct type