Mud-club

Vehicle & Technical => Defender => Topic started by: snezza69 on January 21, 2006, 18:25:52

Title: Mill services rock sliders.
Post by: snezza69 on January 21, 2006, 18:25:52

I just got my new heavy duty rock sliders and went to fit them onto the bare chassis.  Mmmmmmmm  no instructions.  The chassis is a 110 with only the two outriggers.  Anyone had a set of these?

Can some kind sole give me a clue please.

Photos or diagrams would be great.

Thanks.

Title: Mill services rock sliders.
Post by: Stormin on January 21, 2006, 21:10:51

Drop Richard a line at Mill Services. He'll advise you.

Title: Mill services rock sliders.
Post by: snezza69 on January 21, 2006, 21:12:28

That will be my job for Monday, just hoping that someone would be able to help tonight so I can get them on sooner rather than later.

Title: Mill services rock sliders.
Post by: Stormin on January 21, 2006, 21:21:26

Try an e-mail and tell him I told you to :wink:

Title: Mill services rock sliders.
Post by: snezza69 on January 21, 2006, 21:23:51

What's his email address?  I am sure its obvious!

Title: Mill services rock sliders.
Post by: Stormin on January 21, 2006, 21:35:27

sales@mill-services.co.uk or try his web site. www.mill-services.co.uk I'll drop him a line tonight on his home E.

Title: Mill services rock sliders.
Post by: snezza69 on January 21, 2006, 22:30:50

Thanks.

Title: Mill services rock sliders.
Post by: paul_humphreys on January 21, 2006, 22:37:21

At a push ring him. I have the nunber if you carnt find it.

Paul

Title: Mill services rock sliders.
Post by: Jimbo on January 21, 2006, 22:53:55

When I ordered my bars/sliders a couple of weeks ago, Richard asked which version of 110 they were going on - apparently, the hard top chassis only has two chassis outriggers, whereas the station wagons have 3 - hence my post of a few days ago, asking if anyone knew the part number for the third outrigger, as Richard advises fitting it if you want to jack the truck up using the sliders.

Still waiting for my sliders to arrive, so I can't give any advice on fitting them.

Jim

Title: Mill services rock sliders.
Post by: jjsaul on January 22, 2006, 00:46:25

we have a CSW - only 2 outriggers are used

use the one below the B pillar, and the one behind it (under rear seats on a CSW)

the front of the slider goes on the end of the bulkhead bolt.

contact richard from mill - extremely helpful bloke  :D

Title: Mill services rock sliders.
Post by: Stormin on January 22, 2006, 19:25:14

Bit late with this maybe. Had a hectic day.  I contacted Richard and he said instructions should have been with them. But you can phone him on 01948710747 if you still require any advice.

Title: Mill services rock sliders.
Post by: snezza69 on January 22, 2006, 21:40:55

Thanks all, did'nt want to call over the weekend.  Even RIchard deserves down time, will call tomorrow.

Thanks.