Mud-club
Vehicle & Technical => Discovery => Topic started by: kevhenson on January 09, 2006, 19:03:30
-
can someone tell me what the going rate is for getting the cambelt done... reason im asking is have had a few quotes between the £250 and 300 mark...thought it was steep so feeling the ground...can feel a diy job coming on!!
cheers
-
I would have said a couple of hundred is fair. If you supply the parts. I wouldnt tackle it yourself, if you dont have the correct knowledge, or tools.
There are a couple of professional tools you will need. One is a special spanner to get the fan off. The other is a good torque wrench.
Not the easiest DIY job
Im lucky, its my game. :)
-
Kev, depending on when you are doing it, if you get stuck i could give you a hand, have done a few in the past. like has been said a couple of the tasks can be tough, removing the pulley bolt and pulley, but upto now i've managed with a little help from my friends, then again that's wot it's all about, helping each other......
-
My local place does it for around £150-180 ish bring your own parts
They are diesel specialists
-
neil thanks a lot... may take you up on that offer...only thing bothering me about doing the job is actually being able to undo the crank bolt....sposed to be a real tight un!!
hobbit thats a lot better than around here as you can probably tell!
-
nearly forgot.... neil if i do it myself which im def leaning towards wont be til it warms up a bit outside!!!
cheers
-
As Neil says, its relatively easy, as I saw, but then again the pulley and nut were ok. To tell the truth mine was not done more than 20k ago we reckon. So was relatively easy
If its a swine to release just bad luck then, name of the game with these vehicles
-
well, for garages ...
I got quoted at £100 for mine, and should the tensioner and pulley not have needed replacing it would have been that, sadly they did so it ended up at £148.
Still, that's in lancashire (contact ninety for more information if needed) but I would have thought you should be able to find similar locally.
-
I know two local garages I'd trust to do mine, PM/email/sms me for info.
-
i,ve just had 2 quotes for a 300tdi of £215+vat at one place and £250+vat at another
-
£110 fitted including new tensioner roller.etc.....
-
Where was that mate . . . local in Wakefield? - pm if you like :wink:
-
£27-50 for parts :wink:
Labour, four hours of my own time :lol: Worst part was the long bolts around the waterpump, had to be very careful not to snap 'em as they were corroded in :cry:
-
Kev just let me know when and i'll do my best!! If you want you could bring it to my house and do it here when it warms up(maybe 1 Saturday) that way if we struggle i have a few friends nearby to help.Not onlt that but it will be easier for me to get any tools needed from work on the day,
regards Neil...
-
cheers neil that would be great...will give you a shout when temperatures reach double figures...that would be above freezing not below :)