Mud-club
Vehicle & Technical => Series Land Rovers => Topic started by: josh 109 on December 25, 2005, 10:51:48
-
will a safari snorkel off a defender fit a series ?
thanks josh
-
not really without a large amount of modifacation (bodging)a southdown one would be a better bet
-
what sort of modification would be needed ?
-
what sort of modification would be needed ?
LOTS the safari bolts to the outside of the wing & clamps the snorkel,wing & inner ducting together,u would basically have to fit a def wing air intake to make it work where as the southdown goes down through the wing & is supplied with a lenght o flexi rubber hose to go to the air intake
-
thank you for the help , too much work for that so think i will go for a southdown as u sugested
thanks josh
-
that just like my one then :lol:
-
I made mine from drainpipe...
http://www.landyworld.co.uk/diylandroversnorkel.htm gives you the basic info but like many things I start, I never quite finished writing it up!
-
some of the home made jobs look nicer than the ones up for sale think that might be the way to go :lol: :lol:
thanks josh
-
B&Q drain pipe works well...
Here's the last one I made:
http://members.mud-club.com/profiles/Paul/gallery/V8%20Snorkel
-
I like the pic of it 20ft high! Reckon you would get funny looks at pay and play days tho! ;):D
-
I had problems getting under bridges so I had to cut it down. :wink: :lol:
-
that looks very good,were would i get a mushroom top from ? :D
-
Paddocks will sell you a mushroom top for £20.
-
I also made my own from the customary B&Q drainpipe :)
Does anyone know if the ram-air snorkel top (Mantec?) is available seperately and will fit the drainpipe as I prefer the look of them to the mushroom tops?
TIA
-
hi, made mine from the good old drain pipe and the top is a air vent of a 9 tonne ford lorry, one that fits behind the dash blowing it down to the side windows, i took the little flaps off it though after mi mate used to sit andclose them up,
looks good now until today when i realised i had unplugged the heater to fit it, was abit cold in the snow!! hehe
(http://img.photobucket.com/albums/v620/Tractorboy16/4c2af6a5.jpg)
me xxx
-
hi, made mine from the good old drain pipe and the top is a air vent of a 9 tonne ford lorry, one that fits behind the dash blowing it down to the side windows, i took the little flaps off it though after mi mate used to sit andclose them up,
looks good now until today when i realised i had unplugged the heater to fit it, was abit cold in the snow!! hehe
(http://img.photobucket.com/albums/v620/Tractorboy16/4c2af6a5.jpg)
me xxx