Mud-club
Vehicle & Technical => Discovery => Topic started by: xmob on December 12, 2005, 13:12:25
-
Oh dear! :cry:
Is it possible to get Discovery 1 chassis repair sections like you can with Series vehicles?
The man who is swapping my gearbox has just called. He's taken the cross member off and found a hole he can get his fist in. Reckons it'll cost £150 quid because once plated, he'll need to re drill all the mounting holes.
As you can imagine, the missus (and me) is seriously miffed. Stig is proving to be a knackered money pit.
-
im not sure if you can get a replacement part for that section i would think quite a few disco's have got corrosion there coz when i took my cross member off to change my gearbox it was quite corroded but luckily no holes so i cleaned it up and put loads of waxoil/underseal there before putting it back together i dont think £150 is to bad a price for having it plated up. joe
-
no price but they supply it http://www.dls-uk.co.uk/discochassis.htm
or here with price
http://www.rimmerbros.co.uk/cgi-bin/rimmer?findpart&PartID=STC9135&Page=land-rover/discovery/bodywork
Or what about doing a search on ebay for someone scrapping one ?
Peter
-
The gearbox crossmember is a hell of a tight fit on a 200tdi so it's be a heck of a headache to plate it and redrill unless it was cut out.
-
hi, i was looking for a rear crossmember,and came across this site,hope it helps in some way
http://www.mps4x4store.co.uk/about.htm