Mud-club

Vehicle & Technical => Defender => Topic started by: turtle on March 10, 2004, 14:29:21

Title: CV Joint
Post by: turtle on March 10, 2004, 14:29:21

I need to replace the near side CV joint on Turtle (Tixover stickes again!!). My questions are :

1 - Do you need to replace both CV joints, or just the one?

2 - How easy or hard is it to replace?

I have managed to source a new cv joint for 56 quid and looking to fit this weekend coming, if anyone can help.

Thanks

Title: CV Joint
Post by: Pauld on March 10, 2004, 17:01:02

Easy to do, just make sure that you put back everything in the same order, and use locktight in on the bolts.

The biggest problem is ensuring that you have the correct replacement.

Take your chassis number when buying, and don't forget the gaskets and the one shot..

They do not need to be relapced in pairs.

Good Luck!

 :lol:

Title: end float
Post by: Sharpshooter on March 10, 2004, 19:19:34

dont forget when you have fitted the new cv joint, that you check that the end float is the same on the half shaft. It should show you how to do this in a haynes manual. :D

Title: CV Joint
Post by: turtle on March 11, 2004, 09:26:57

Many Thanks gents for your advice, I will let you know how I got on.

Title: CV Joint
Post by: hobbit on March 11, 2004, 15:10:25

You don't have to change both is one has gone, but preventative maintenance might be advisable, would you only change one disc or set of pads for one side of an axle?

Me personally would do the pair, same as track rod ends etc

Kev

Title: CV Joint
Post by: turtle on March 11, 2004, 16:34:30

Kev - you have the same train of thought as me, hence the question should I change both CV's?

But general advise seems to be just change the one. As 'Turtle' cost me quite a bit this week with new alternator, now CV and I still got the winch to sort, so shes just getting the one replaced.

Title: CV Joint
Post by: hobbit on March 11, 2004, 17:22:29

Thats the problem then, you made the right choice, safety to keep it on the road, but put it on a do do list for the near future when funds allow.
If one has gone the other must be wearing too.

Kev

Title: CV Joint
Post by: turtle on March 12, 2004, 09:29:25

Quote from: "hobbit874"

If one has gone the other must be wearing too.

Very true, I will get the other checked and replaced as soon as funds allow, or when wife gives me back my credit card  :D  :D

Title: CV Joint
Post by: muddyweb on March 12, 2004, 20:23:37

Personally I wouldn't bother doing them both until the other one shows signs of failure.  Give the fact that the vehicle is regularly used off-road, the cause of failure is unlikely be just down to wear and tear.

There is no advantage in terms of the logistics of the job in doing them both, and they aren't a cheap part, so spreading the cost is preferable too.   They don't fall into the same category as brake pads or track rod ends, since the difference in performance of a new and an existing unit is virtually non-existant.

Just my 2p worth ;-)

Title: CV Joint
Post by: turtle on March 22, 2004, 10:03:41

CV joint replaced, in the end I didn't have time to do the job myself, got it booked in with a local company which took them a hour and 20 mins to sort. Well pleased that I didn't have to get my hands dirty  :D  this time.