Mud-club

Vehicle & Technical => Discovery => Topic started by: yer auld aunt nelly on November 10, 2005, 14:59:49

Title: just a quicky
Post by: yer auld aunt nelly on November 10, 2005, 14:59:49

how easy or not ,is it to remove the doors on a disco any one done it? whats the best way of doing of going about it.  :wink:

Title: just a quicky
Post by: hobbit on November 10, 2005, 17:53:55

Piece of water :wink:

Just have to undo the wiring loom out of the door, remove the pin holding the stop bar, and theres a c clip on the two hinge pins top and bottom, these just pop off, and then lift away :wink:

Be ready though bit in the heavy side on your own

Title: just a quicky
Post by: landyman Ash on November 10, 2005, 19:04:26

Its actually quite scary how easy they do come off  :shock:  :shock:  :shock:  :shock:  :shock:  :shock:

If it takes you more then 10 mins, you must of stopped for a cuppa  :wink:

Title: well i never
Post by: yer auld aunt nelly on November 11, 2005, 08:03:55

:shock:  :shock:  :shock:  :shock:  :shock:  :shock:  :shock:  :shock:  :shock: you are having a laugh its that easy!!

Title: just a quicky
Post by: hobbit on November 11, 2005, 11:45:29

Nope, I was amazed myself

pop the panel on the footwell to access the plugs for the cables, push the pin up and out on the door stop and 2 c clips one top one bottom

(btw, leave the window closed (if its electric) otherwise its hard to access the components in the door, unless that is what you want to work on)