Mud-club

Vehicle & Technical => Defender => Topic started by: yer auld aunt nelly on October 30, 2005, 02:40:40

Title: do u know?
Post by: yer auld aunt nelly on October 30, 2005, 02:40:40

alright i give up,does anyone know who makes footwell repair sections!!  :roll:

Title: do u know?
Post by: datalas on October 30, 2005, 07:42:25

"make" might be a bit on the complicated side, you should be able to buy an entire replacement footwell err "panel" from craddocks / paddocks / the like for very little money.

ISTR I got a pair (enough for both sides) for less than £60 ...

Although, their websites are being somewhat useless (no shock there then)

Title: theres more
Post by: yer auld aunt nelly on October 30, 2005, 17:49:42

it may be worse than i thought by the look of it might be needing a complete bulkhead! while im there might as well make it galvinised one any ideas? once again just cant find any.Have you had more luck?If so let me know ta   :wink:

Title: do u know?
Post by: landyman Ash on October 30, 2005, 21:35:43

Its cheaper to buy a new one off ebay (only looking the £150 to £200 mark) and get it galvanised yourself

A new one should last ten years so is it worth galvanising??  :?

Title: do u know?
Post by: datalas on October 31, 2005, 07:33:59

also be warned that galvanising has been known to twist things at times, doing this to a bulkhead might not be good, unless you want your doors facing different ways :)

Although, apparently thicker steel is fine and dandy, the trouble is that newer bulkheads are made out of mr kipling wrappers :D