Mud-club

Vehicle & Technical => Series Land Rovers => Topic started by: DAVE V8 on November 23, 2009, 23:20:51

Title: series 2,swb,diff ratio??
Post by: DAVE V8 on November 23, 2009, 23:20:51

hi,broke the rear diff sunday,play day,just taken it out 46 teeth  and 13 on the pinion ,planet gears all breaking up,am i right that this is a 3.5 diff,also what vehicle will i be able to get one from,is it disco ,range rover.??any advise appreciated,hoping to fix for sunday to go to whaddon,cheers dave..

Title: Re: series 2,swb,diff ratio??
Post by: maggers on November 27, 2009, 21:19:57

Hi, If it is a 3.54 then one from an early Discovery/RRC will fit, just check the number of driveshaft splines is the same. :D

Title: Re: series 2,swb,diff ratio??
Post by: NiteMare on November 29, 2009, 00:09:51

if you use a disco diff then you'll have to refill the oil thru the end of the axle tube if there's no filler plug in the diff pan, just jack the axle high one side and pull the halfshaft to fill a measured amount

Title: Re: series 2,swb,diff ratio??
Post by: tack43 on November 29, 2009, 21:35:08

90/110 10 spline will fit as well.

Rich

Title: Re: series 2,swb,diff ratio??
Post by: Range Rover Blues on December 24, 2009, 18:23:11

Quote from: NiteMare on November 29, 2009, 00:09:51

if you use a disco diff then you'll have to refill the oil thru the end of the axle tube if there's no filler plug in the diff pan, just jack the axle high one side and pull the halfshaft to fill a measured amount

Depending what yearof RRC you get, they either had fillers in the diff casing or the axle casing, diff casing are earlier and IIRC the imperial diff, the platform for the plug hole is still cast on later diffs but not used.

Title: Re: series 2,swb,diff ratio??
Post by: bogie on December 24, 2009, 18:43:07

I  have an early 3.5 with a filler if you want to buy her?