Mud-club
Vehicle & Technical => Defender => Topic started by: burgerman on June 10, 2008, 16:38:30
-
Following on from a previous thread ----- Wifeys 90, A 2001 TD5 CSW, appears to have saggy springs :( , But before i order up a new set (with dampers) can i compare my measurements please ?? From the centre of the wheel/hub to the bottom edge of the Wheel arch trim is 19 inches front and the same on the back ,
So before my itchy finger is hovering over the BUY button :lol: could some please pop out n measure theres please ??
Many thanks
-
110 Td5 hardtop (ok, not quite the same vehicle :oops:)
21" rear
20.5" front
And that's on 265/75/16 MT's
-
does the workshop manual not state the proper ride height measurements? sure I seen a diagram somewhere.
-
does the workshop manual not state the proper ride height measurements? sure I seen a diagram somewhere.
Dunno :-k Havent even got a haynes manual for it :roll:
Thought it had overall vehicle heights on the inside if the sunvisors somewhere ? but not that i can find anymore :doh:
Might pop up the main stealers this afternoon and sneak around with a tape measure :lol: