Mud-club

Vehicle & Technical => Series Land Rovers => Topic started by: auf_wiedersehen_pet on April 03, 2007, 21:25:02

Title: Fitting Modulars on a LR Series 1 - Studs thin and short!!
Post by: auf_wiedersehen_pet on April 03, 2007, 21:25:02

Evening all,

Seen a cracking Series 1 with Modulars. Much better stance.

Anyhow, bought some and the studs are a bit short and a bit thin for the modulars. Can I fit replacements easily?

Cheers

Rob

Title: Fitting Modulars on a LR Series 1 - Studs thin and short!!
Post by: auf_wiedersehen_pet on April 03, 2007, 21:38:01

Seen these...

http://cgi.ebay.co.uk/LAND-ROVER-SERIES-PUSH-IN-TYPE-HUB-STUDS-x5_W0QQitemZ4524409006QQcategoryZ31348QQrdZ1QQssPageNameZWD1VQQcmdZViewItem

Would this do the trick?

Cheers

Rob

Title: Fitting Modulars on a LR Series 1 - Studs thin and short!!
Post by: bob86 on April 03, 2007, 22:46:06

Quote from: "auf_wiedersehen_pet"

Seen these...

http://cgi.ebay.co.uk/LAND-ROVER-SERIES-PUSH-IN-TYPE-HUB-STUDS-x5_W0QQitemZ4524409006QQcategoryZ31348QQrdZ1QQssPageNameZWD1VQQcmdZViewItem

Would this do the trick?

Cheers

Rob

Those are larger in diameter but the same length.

Title: Fitting Modulars on a LR Series 1 - Studs thin and short!!
Post by: auf_wiedersehen_pet on April 04, 2007, 08:41:45

Thanks for point that out. I was ready to buy them!

Cheers

Rob

Title: Fitting Modulars on a LR Series 1 - Studs thin and short!!
Post by: bob86 on April 04, 2007, 18:33:37

I did do thats why i know. :roll:
To fit them you also need to recess the back of the hubs so the flange sits flush or they end up even shorter than the ones you have.