Mud-club
Vehicle & Technical => Discovery => Topic started by: 300TDi Disco on July 23, 2010, 20:33:03
-
Hi, I can see that the rear doughnut is starting to split. I have heard off a few people in the past, that i can replace it with a 200 prop. I am just trying to find out what i exactly need.
Regards
-
Alrite Matt,
You need an STC4858 flange kit and a prop off a 200 disco.
See here (http://forums.lr4x4.com/index.php?showtopic=13110) for how to do it.
-
Cheers Chris.
-
If you fit a new doughnut then replace the spigot bush too.
-
i not had any problems with mine since i changed to the 200 prop
-
My LSE runs fine with the doughnut, but TBH I can't see the point of it. Our TDi has already been swapped and finger's crossed is fine.
For higher prop angles I'd fit the 200 prop.
-
Cheers for your reply's. I am tring to find a flange from somewhere does anyone know where i could get one???
-
Ask around for a busted diff.
-
hi there all i did was fit a front diff in the back and a 200 prop had it on for 1 year and had no prop's this might be easier :lol:
-
i got mine from jsf
-
I think the 61mm flange kit is STC4858 IIRC, If you use a std length 41mm 200 flange you need a 12mm spacer which Ashcroft transmissions sell for around
-
Cheers for your reply's. I am tring to find a flange from somewhere does anyone know where i could get one???
Try this (http://tinyurl.com/27ewhvb) :doh: :lol:
-
Cheers for your reply's. I am tring to find a flange from somewhere does anyone know where i could get one???
Try this (http://tinyurl.com/27ewhvb) :doh: :lol:
:lol: :lol: :lol: :lol:
Im also looking at doing this as my coupling has failed on me.... not much fun driving home. Will any adjustments need to be made REF- preloads if the flanges are changed?
-
nah, preloads are 'inside' the diff, changing the flange is outside the diff