Mud-club

Vehicle & Technical => Series Land Rovers => Topic started by: AJC on February 03, 2009, 10:40:21

Title: Land Rover 90 electrical issues...
Post by: AJC on February 03, 2009, 10:40:21

i have a M reg 300tdi,for some reason the indicators have stopped working, they worked fine and then i wnet to use them and nothin, is it common for the stalks to go nakered?

also, my fuel gauage and temp sender have also stopped working, but popped back on the other night when i hit a bump and then of again, i have checked the connections in the top of the tank and they are fine

any help be greatly apreciated

Title: Re: Land Rover 90 electrical issues...
Post by: carbore on February 03, 2009, 13:32:34

On my series 3 it was the fuse holder as they all share the same one I think. The fuse holder was corroded. A quick whizz with wire wooll/emery paper and its fine. If you use wire woll obviously be careful not to leave any around to short things out. In fact use paper not wool.

Title: Re: Land Rover 90 electrical issues...
Post by: AJC on February 03, 2009, 18:01:09

thank you, i forgot to put tho, that my hazards work fine, surely they wouldn't if that was faulty

Title: Re: Land Rover 90 electrical issues...
Post by: Dennis the diesel on February 06, 2009, 21:02:26

Hi Folks
Had a similar problem with my older 90 a few years ago (just in time for the M.o.T...) where the indicators wouldn't but the hazards did work.
turned out that the hazard switch was, in fact, 'Broken'!
Swapped it for a known 'good' switch and all was well, and got the ticket from Mr. M.o.T.

Don't ask me how it works, but it did.

Hope this helps,

Regards,  Chris