Mud-club
Vehicle & Technical => Range Rover => Topic started by: generation-x on August 27, 2010, 21:34:56
-
carb'ed v8 snorkle anyone got any pix i can look @?
Simon
-
Most important that you avoid to many bends or changes in diameter if you intend to use it all the time.
-
Simon,
Check out the linky below for my patented V8 B&Q snorkel... ok.. it was a disco... but hey... might work for you!
http://www.mud-club.com/galleries/Skibum346/3756-Building-a-Home-Made-Snorkel/ (http://www.mud-club.com/galleries/Skibum346/3756-Building-a-Home-Made-Snorkel/)
Skibum
-
On my V8 I blanked off the front air entry to the airbox, then made a flange and fixed it to the side, avoiding a tight U bend, then onwards via a piece of hose to B&Q pipe, easily replaced if broken. Been on a while now and taken some knocks, still looks good.
Dave
-
You can see a couple of shots of mine here (http://www.mud-club.com/galleries/Range-Rover-Blues/6004-RRB-Snorkel/)
-
just finished mine its a 200 tdi disco one with a bit of moding to the bonnet
(http://inlinethumb32.webshots.com/47967/2151457150103135405S600x600Q85.jpg) (http://entertainment.webshots.com/photo/2151457150103135405fRToia)
(http://inlinethumb18.webshots.com/46865/2564911590103135405S600x600Q85.jpg) (http://entertainment.webshots.com/photo/2564911590103135405GHANNf)
-
That's pretty neat.
-
Some photo's of one of mine HERE (http://www.mud-club.com/galleries/Paul/923-Home-Made-V8-Snorkel)