Mud-club

Vehicle & Technical => Discovery => Topic started by: Telaren on April 09, 2007, 17:46:46

Title: Disco 1 - 200TDI Brake Caliper Question ?????????
Post by: Telaren on April 09, 2007, 17:46:46

Can anyone help?   :?

I have a Disco 1 - 200TDI on a 93 Plate.

I need to know what size the brake caliper pipe connectors are.

I am replacing the copper pipes.

Cheers Taz

Title: Disco 1 - 200TDI Brake Caliper Question ?????????
Post by: Telaren on April 11, 2007, 11:21:19

Getting Desperate!   :lol:

Title: Disco 1 - 200TDI Brake Caliper Question ?????????
Post by: Leslie Henson on April 11, 2007, 12:24:16

M10 fine thread.
You can re-use the old fittings if they are in good condition and not mullered with mole grips/hammer and chisel/temperatures equivalent to the suns core. You will need male fittings for where the pipe connects to the pipe union. Brake pipe (not the rubber hose) is 3/16" and you need to buy a packet of cupro-nickel brake pipe. It comes in 25ft rolls and should cost you about a tenner. Ask for 10mm male brake pipe unions - about 20p each.


Les.

Title: Disco 1 - 200TDI Brake Caliper Question ?????????
Post by: Telaren on April 11, 2007, 12:43:49

Quote from: "Leslie Henson"

M10 fine thread.
You can re-use the old fittings if they are in good condition and not mullered with mole grips/hammer and chisel/temperatures equivalent to the suns core. You will need male fittings for where the pipe connects to the pipe union. Brake pipe (not the rubber hose) is 3/16" and you need to buy a packet of cupro-nickel brake pipe. It comes in 25ft rolls and should cost you about a tenner. Ask for 10mm male brake pipe unions - about 20p each.


Les.

Is that M10 x 1.0  or M10 x 1.25?

Cheers  Taz