Mud-club
Vehicle & Technical => Series Land Rovers => Topic started by: diff-breaker on May 20, 2005, 19:29:03
-
Got new cab (roof and sides) before got the new Series III and was wondering - is there any sealing strip to go between the new cab and the rear panels or is it literally just bolt and go !!!
-
yes there is! just got mine from Candol as I am fitting a new roof and side panels soon. They are rubber seals and were ordered in, only took 2 days,
Good luck with it,
Dave
-
go to B&Q and find some stick on rubber insulating strip, will be cheaper than the genuine part and might actually work
although, it's a series, just take a drill to the roof and turn it into a cullendar for all the water retention it has :)
-
Could always use old bike tubes and silicon :wink:
-
thanks for all your replies - like the sound of bike tubes - can inflate them and might float in deep water ?
-
thanks for all your replies - like the sound of bike tubes - can inflate them and might float in deep water ?
Hmmm hadn't though of that, would be interesting to see them bulge at the sides though :lol: