Mud-club
Vehicle & Technical => Defender => Topic started by: ridgeback26 on February 06, 2004, 11:30:17
-
I am doing an engine swap from 2.5Na to 200tdi . does any one no what the 2 small brackets with a small pin on each one that stick out both sides or the rad/intercooler frame about half way up are for. The old 2.5 rad did not have any and with them on there it look likes i will have to cut the inside of the front to fit the new rad.
-
i'll go and have on mine for you but might be this evening before i get back to you
-
I've had a look mine and there is on bracket on the side of the rad or intercooler when i get chance i'll take some photos and post them for you ok bud
-
Thanks for looking for me. If you can send me some photos that would help. I can cut them off if i do not need them but it would be good to see the photos befor i hit them with the grinder