Mud-club
Vehicle & Technical => Defender => Topic started by: 110landy on July 03, 2008, 15:31:30
-
hello there
my 110 has bad rust problems and i need some advice,
the other day i was jacking the rear drivers side when the bumper started to crumble :'( i need to know if it is possible to replace this or do i need to start looking for a new chassis, the chassis i perfect no rust and is very clean just the rear :?
-
When you say bumper - do you mean the rear crossmember, the black/rusty coloured lump of steel that runs the full width of the rear of the vehicle ?
If it is, then the simple answer is yes - you can get a new one, it's not a bolt on job, the old one needs cutting off, and the new one needs to be properly welded on.
-
yes thats what i mean ;)
im new too landys so still learning
thank you for the hep
-
You can repair the crossmember if it's not too bad, but judging from what you say - it needs replacing.
What you are letting yourself in for :)
http://forums.lr4x4.com/index.php?showtopic=24885 (http://forums.lr4x4.com/index.php?showtopic=24885)
Les.