Mud-club

Vehicle & Technical => Suzuki => Topic started by: MIGHTYMINI-5 on May 31, 2010, 14:17:00

Title: sorry me again
Post by: MIGHTYMINI-5 on May 31, 2010, 14:17:00
advise/help/ideas
needed please
have two front bumpers both need adapting to fit vit
one has been awinch bumper the other will need adapting
i think the one that needs adapting looks better as pipe smaller diameter and will give me better aproach angel
but will need to cut panel in between headlights
also a good welder will be req as my welding is not good enough to trust this job to
basically i dont want to make a rushed decision and cut etc and then regret it because it was the wrong way to go so am after some knowledge and advice etc
cheers shaun

(http://i563.photobucket.com/albums/ss73/mightymini-5/Image0194.jpg)
(http://i563.photobucket.com/albums/ss73/mightymini-5/Image0195.jpg)
(http://i563.photobucket.com/albums/ss73/mightymini-5/Image0192.jpg)
(http://i563.photobucket.com/albums/ss73/mightymini-5/Image0193.jpg)
(http://i563.photobucket.com/albums/ss73/mightymini-5/Image0191.jpg)

then this to go on top
 
(http://i563.photobucket.com/albums/ss73/mightymini-5/Image0196.jpg)

then this

(http://i563.photobucket.com/albums/ss73/mightymini-5/Image0197.jpg)
Title: Re: sorry me again
Post by: generation-x on June 02, 2010, 18:47:12
shaun
i like the 2nd one
with some good bracing you cud make the winch de-mountable save your springs
when not needed to be on the front then

something like dave jones used to have on superzuki

Si
Title: Re: sorry me again
Post by: MIGHTYMINI-5 on July 28, 2010, 22:21:00
yipeeeeeeeeeeeeee
DONE ish

all mot'd

(http://i563.photobucket.com/albums/ss73/mightymini-5/Image0231.jpg)

(http://i563.photobucket.com/albums/ss73/mightymini-5/Image0233.jpg)

(http://i563.photobucket.com/albums/ss73/mightymini-5/Image0232.jpg)
SimplePortal 2.3.5 © 2008-2012, SimplePortal